Von Neumann Architecture (Cambridge (CIE) IGCSE Computer Science): Revision Note
Exam code: 0478 & 0984
Von Neumann Architecture
What is the Von Neumann architecture?
The Von Neumann Architecture is a design of the CPU which was proposed by Mathematician John Von Neumann in the 1940s, which most general-purpose computers are built upon
The Von Neumann Architecture outlines how the computer memory, input/output devices and processor all work together

The Von Neumann architecture consists of:
Control unit (CU)
Arithmetic logic unit (ALU)
Registers
Buses
What is the function of each component?
Arithmetic logic unit (ALU)
Performs arithmetic operations
Performs logical decisions
IF X > 5 THEN
DO ……….
Control unit (CU)
Coordinates how data moves around the CPU by sending a signal to control the movement of the data
Decodes the instructions fetched from memory
Registers
Extremely small, extremely fast memory located in the CPU
Hold small amounts of data needed as part of the fetch-execute cycle
Each register has its own specific purpose
It consists of 5 main registers
The Program Counter (PC)
The Memory Address Register (MAR)
The Memory Data Register (MDR)
The Accumulator (ACC)
Current Instruction Register (CIR)
For each of the registers you must know
The name of the register
Its acronym
The purpose of the register
Examiner Tips and Tricks
When describing registers like the PC, MAR, or MDR, don’t just name what they “store”, you must also explain why they store it and how it’s used in the fetch-execute cycle. The how is where marks are gained or lost.
Name | Acronym | Purpose |
|---|---|---|
Program Counter | PC |
|
Memory Address Register | MAR |
|
Memory Data Register | MDR |
|
Current Instruction Register | CIR |
|
Accumulator | ACC |
|
Buses
Components within the CPU and wider computer system are connected by buses
A bus is a set of parallel wires through which data/signals are transmitted from one component to another
There are 3 types of bus:
Address - unidirectional, carries location data (addresses), data is written to/read from
Data - bidirectional, carries data or instructions
Control - bidirectional, carries commands and control signals to tell components when they should be receiving reads or writes etc..

Examiner Tips and Tricks
For a register, give what it holds and what it is used for, for example "the MAR holds the address of the data or instruction to be fetched from memory". The ALU is not a register.
The address bus carries memory addresses in one direction only. The data bus carries data and instructions in both directions.
Worked Example
Describe the role of the control unit, the control bus, the data bus and the address bus when fetching an instruction from memory [4]
Answer
The address of memory (holding instruction) is placed on the address bus (1)
The control unit sends a signal (1) on the control bus (to start a read operation) (1)
The instruction is/the contents of the memory are placed on the data bus (1)
Unlock more, it's free!
Was this revision note helpful?
Build on this topic