The Henderson-Hasselbalch Equation (College Board AP® Chemistry): Study Guide

Philippa Platt

Written by: Philippa Platt

Reviewed by: Stewart Hird

Updated on

The Henderson-Hasselbalch equation

  • The pH of a buffer solution can be calculated using:

    • The Ka of the weak acid

    • The equilibrium concentration of the weak acid and its conjugate base

  • To determine the pH, the concentration of hydrogen ions is needed which can be found using the equilibrium expression:

Ka = [H3O+][A−][HA]

  • This rearranges to:

[H3O+] = Ka × [HA][A−]

  • To simplify the calculations, logarithms are used such that the expression becomes:

−log [H3O+] = −log Ka − log [HA][A−]

  • Since −log [H+] = pH, the expression can also be rewritten as:

pH = pKa + log [A−][HA]

  • This is known as the Henderson-Hasselbalch equation

Examiner Tips and Tricks

You will not be asked to derive this equation on the AP Exam; the steps above only show where it comes from

  • For a buffer made from a weak base, B, and its conjugate acid, HB+

  1. Find the pKa of the conjugate acid:

pKa = 14.00 − pKb at 25 °C

  1. Then use:

pH = pKa + log [B][HB+]

Worked Example

Calculate the pH of a buffer solution containing 0.305 M acetic acid and 0.520 M sodium acetate.

(pKa of acetic acid = 4.74)

Answer:

Step 1: Write down the Henderson-Hasselbalch equation

pH = pKa + log [A−][HA]

Step 2: Substitute in values

pH = 4.74 + log (0.5200.305)

pH = 4.74 + 0.232

pH = 4.97 (given to 2 d.p.)

Worked Example

Calculate the pH of a buffer solution containing 0.0400 M ethylamine and 0.0865 M ethylammonium chloride.

(pKb of ethylamine = 3.99)

Answer:

Step 1: Find the pKa of the conjugate acid, C2H5NH3+

pKa = 14.00 − pKb

pKa = 14.00 − 3.99

pKa = 10.01 (at 25 °C)

Step 2: Substitute in values

pH = pKa + log [C2H5NH2][C2H5NH3+]

pH = 10.01 + log 0.04000.0865

pH = 10.01 − 0.335

pH = 9.68 (given to 2 d.p.)

Examiner Tips and Tricks

Use the Henderson–Hasselbalch equation only for a buffer, where both the weak acid and its conjugate base are present in large amounts. For a weak acid on its own, use Ka and an equilibrium (ICE) table instead

Keep the ratio as conjugate base over acid, [A−]/[HA]. More A− than HA gives a pH above pKa

The logs are base 10. To find the ratio [A−]/[HA] from a pH, raise 10 to the power (pH − pKa), not e

What happens when acids and bases are added to a buffer solution?

Consider acetic acid and sodium acetate as a buffer system

CH3COOH (aq) ⇌ CH3COO– (aq) + H+ (aq)

When H+ ions are added to an acidic buffer:

  • The equilibrium position shifts to the left as H+ ions react with CH3COO- ions to form more CH3COOH until equilibrium is re-established

CH3COO- (aq) + H+ (aq) → CH3COOH (aq)

  • As there is a large reserve supply of CH3COO-, the concentration of CH3COO- in solution does not change much as it reacts with the added H+ ions

  • As there is a large reserve supply of CH3COOH, the concentration of CH3COOH in solution does not change much as CH3COOH is formed from the reaction of CH3COO- with H+

  • The ratio [A-]/[HA] does not change significantly, so the pH of the solution does not change significantly

When OH- ions are added to an acidic buffer:

  • The added OH- reacts with the weak acid, CH3COOH, which is present in large amounts:

CH3COOH (aq) + OH- (aq) → CH3COO- (aq) + H2O (l)

  • This converts a little CH3COOH into CH3COO-, so the ratio [A-]/[HA] changes only slightly

  • As there is a large reserve supply of CH3COOH, the concentration of CH3COOH in solution does not change much as it reacts with the added OH- ions

  • As there is a large reserve supply of CH3COO-, the concentration of CH3COO- in solution does not change much

  • The ratio [A-]/[HA] does not change significantly, so the pH of the solution does not change significantly

Changing concentrations of HA and A-

  • The Henderson-Hasselbalch equation shows how the pH of a buffer changes when the concentrations of HA and A- change

pH = pKa + log [A−][HA]

  • For example,

    • A common buffer contains CH3COOH and CH3COO–

    • If the ratio [CH3COO-]/[CH3COOH] changes, the pH of the buffer changes

Ratio of [CH3COOH] and [CH3COO–] in a buffer

Three particle diagrams of an acetic acid/acetate buffer. Key: a plain circle is CH₃COO⁻; a circle with a small attached dot is CH₃COOH. Left: 5 of each, pH = pKa. Middle: 5 CH₃COOH and 3 CH₃COO⁻, pH < pKa. Right: 3 CH₃COOH and 5 CH₃COO⁻, pH > pKa.

The pH of a buffer depends on the ratio [CH3COO-]/[CH3COOH]: more conjugate base than acid gives a pH above pKa

  • Starting from:

pH = pKa + log10 [CH3COO−][CH3COOH]

  • If [CH3COOH] and [CH3COO–] are equal:

pH = pKa

  • If [CH3COOH] is greater than (>) [CH3COO–]

pH < pKa

  • If [CH3COOH] is less than (<) [CH3COO–]

pH > pKa

Unlock more, it's free!

Join the 100,000+ Students that ❤️ Save My Exams

the (exam) results speak for themselves:

Build on this topic

Philippa Platt

Author: Philippa Platt

Expertise: Chemistry Content Creator

Philippa has worked as a GCSE and A level chemistry teacher and tutor for over thirteen years. She studied chemistry and sport science at Loughborough University graduating in 2007 having also completed her PGCE in science. Throughout her time as a teacher she was incharge of a boarding house for five years and coached many teams in a variety of sports. When not producing resources with the chemistry team, Philippa enjoys being active outside with her young family and is a very keen gardener

Stewart Hird

Reviewer: Stewart Hird

Expertise: Chemistry Content Creator

Stewart has been an enthusiastic GCSE, IGCSE, A Level and IB teacher for more than 30 years in the UK as well as overseas, and has also been an examiner for IB and A Level. As a long-standing Head of Science, Stewart brings a wealth of experience to creating Topic Questions and revision materials for Save My Exams. Stewart specialises in Chemistry, but has also taught Physics and Environmental Systems and Societies.