Air Quality & Climate (Cambridge (CIE) IGCSE Chemistry): Alternative to Practical Questions

Exam code: 0620 & 0971

4 hours52 questions
1a
2 marks

A student investigated the reaction of air with copper. 100cm3 of air was passed continuously over heated copper using the apparatus below. When the volume remained constant, the apparatus was left to cool and the volume of gas was measured.

composition-of-air-experiment-blanks

a) i) Complete the box to show the apparatus labelled.

 

[1]

 ii) Indicate on the diagram, with an arrow, where heat is applied.

 [1]

1b
1 mark

b) What should be used to transfer the copper from a bottle to the apparatus?

 [1]

1c
1 mark

c) The copper changed colour from brown to ..............................

 [1]

1d
2 marks

d) Why was the apparatus left to cool before measuring the final volume of gas?

 [2]

2
6 marks

Two liquid fuels, F and G, both burn in air to produce carbon dioxide and water.

A student is asked to find out which of the two fuels produces more carbon dioxide for each gram of fuel burned.

Plan an investigation that the student could carry out.

Your plan should include:

  • the apparatus needed

  • the method to use and the measurements to take

  • the variables that must be controlled

  • how the results should be used to reach a conclusion

3a
2 marks

A power station burns coal that contains sulfur compounds. The waste gases that leave the power station contain sulfur dioxide.

A student models the removal of sulfur dioxide from the waste gases. A sample of the waste gas is passed through a tube packed with lumps of calcium oxide.

The gas is tested before it enters the tube and again after it leaves the tube.

Describe a test, and the result of the test, that shows the gas entering the tube contains sulfur dioxide.

3b
2 marks

The same test is carried out on the gas after it leaves the tube packed with calcium oxide.

State the result of this test.

Explain the result.

3c
1 mark

State one safety precaution, other than wearing eye protection, that should be taken when carrying out this experiment.

3d
2 marks

In a power station, sulfur dioxide is removed from the waste gases using calcium oxide.

Name this industrial process.

State the environmental problem that it is used to reduce.

4a
1 mark

A student determines the percentage of oxygen in air.

A sample of air is passed backwards and forwards between two gas syringes, over copper that is heated in a silica tube. The copper reacts with the oxygen in the air. An excess of copper is used.

The gas is allowed to cool to room temperature before the final volume is measured.

The results of four trials are shown.

trial

initial volume of air / cm3

final volume of gas / cm3

1

100.0

79.0

2

80.0

63.2

3

60.0

54.0

4

40.0

31.6

The gas remaining at the end of each trial is mostly nitrogen.

Name the group of elements that makes up most of the rest of the remaining gas.

4b
2 marks

The air is passed backwards and forwards over the heated copper several times, until the volume of gas no longer changes.

Explain why the air is passed over the copper more than once.

4c
2 marks

In trial 1, the initial volume of air was 100.0 cm3 and the final volume of gas was 79.0 cm3.

Use these results to calculate the percentage of oxygen in the air.

4d
2 marks

One of the four trials gives an anomalous result.

Identify the anomalous trial.

Suggest a reason for the anomalous result.