Cell Potential Under Nonstandard Conditions (College Board AP® Chemistry): Study Guide
Cell potential & equilibrium
Deviations from standard conditions and cell potential
Equilibrium arguments, such as Le Châtelier’s principle, do not apply to electrochemical systems because these systems are not in equilibrium
The cell potential is a driving force toward equilibrium: the farther the reaction is from equilibrium, the greater the magnitude of the cell potential
Under standard conditions:
Every solution is 1 M
Every gas is at 1 atm
So, the reaction quotient, Q, is equal to 1
For the cell reaction Zn (s) + Cu2+ (aq) → Zn2+ (aq) + Cu (s), the reaction quotient, Q, is:
Q =
Q is written as for any reaction (Unit 7): products over reactants, each raised to its coefficient
Solids are not included
Since we know that the standard cell potential is calculated at 1 M and 1 atm, we know that the value for Q (the reaction quotient) would have to be 1
As a cell reaches equilibrium, the reaction quotient reaches the equilibrium constant, K, (Q = K ) and the magnitude of the cell potential decreases to zero
At equilibrium, the cell produces no voltage
A value for the cell potential of zero means that the reaction has reached equilibrium
Changing a concentration changes the magnitude of Ecell
The cell is no longer operating under standard conditions
Changing both concentrations by the same factor does not change the cell potential
If [Zn2+] and [Cu2+] are both 0.50 M, Q = 0.50/0.50 = 1, so E stays 1.10 V
Changing concentrations in a galvanic cell

Standard conditions in a Zn/Zn2+ Cu2+/Cu cell
Zn (s) → Zn2+ (aq) + 2e− | E° = −0.76 V | Oxidation |
Cu2+ (aq) + 2e− → Cu (s) | E° = +0.34 V | Reduction |
E°cell = E°cathode − E°anode
E°cell = 0.34 − (−0.76) = 1.10 V
These calculations illustrate the trend
On the AP Exam, you should reason from Q, not calculate E
If the concentrations are changed to:
New Concentration | New Concentration |
|---|---|
[Zn2+] = 5.00 M [Cu2+] = 1.00 M | [Zn2+] = 1.00 M [Cu2+] = 5.00 M |
Q = 5 | Q = 0.2 |
Overall equation: E = E° − (RT/nF) ln Q Known values:
| |
E = 1.10 − ln 5 | E = 1.10 − ln 0.2 |
E = 1.10 − 0.02 = 1.08 V which is now a lower value | E = 1.10 − (−0.02) = 1.12 V which is now a higher value |
Q = 5 is closer to equilibrium (K is very large) than Q = 1, so the magnitude of the cell potential decreases relative to E°cell | Q = 0.2 is further from equilibrium than Q = 1, so the magnitude of the cell potential increases relative to E°cell |
Concentration cells
A voltage can be generated by constructing an electrochemical cell in which each compartment contains the same redox active solution but at different concentrations
The voltage is produced as the concentrations equilibrate
For example, if we look at the following cell containing two different concentrations of zinc sulfate solution
Diagram to show two different concentrations of zinc sulfate in a concentration cell

Reduction occurs at the more concentrated half-cell and oxidation occurs at the less concentrated half-cell
The two different reactions taking place are:
Oxidation occurs in the less concentrated half-cell (the anode):
Zn (s) → Zn2+ (aq, 0.50 M) + 2e−
Reduction occurs in the more concentrated half-cell (the cathode):
Zn2+ (aq, 1.00 M) + 2e− → Zn (s)
Electrons flow through the wire from the less concentrated half-cell to the more concentrated one
This makes the dilute solution more concentrated and the concentrated one more dilute, moving the cell toward equilibrium
So for this reaction, E°cell = 0 (both half-reactions are the same)
E°cell = E°cathode − E°anode
E°cell = −0.76 − (−0.76) = 0.00 V
From the concentrations of the two different solutions of zinc sulfate, we can calculate the value for Q, or the reaction quotient
Solids are not included in this calculation
The cell reaction is:
Zn2+ (aq, 1.00 M) → Zn2+ (aq, 0.50 M)
So, Q is:
Q =
Q = = 0.50
Therefore:
E = E° − ln Q
E = E° − ln 0.50
E = +8.91 × 10−3 V
E is positive, so the cell reaction is thermodynamically favored in this direction
As the concentrations of each half cell get closer together over time, the value for Q will increase and Ecell will decrease
When Q = 1 the reaction is at equilibrium and E is equal to 0
When the two concentrations are equal, Q = 1, which is K for a concentration cell, so there is no driving force and E = 0
Unlock more, it's free!
Was this revision note helpful?
Build on this topic